Denon Avr 3808 Update
I just ran the firmware upgrade on my 3808CI (US) and now the Audessy calibraion fails to start. The following is the readouts from the display:SER#: xxxxx03108MAIN VER: 01.57SUB VER: 00.38DSP1 VER: 36.49DSP2 VER: 39.41GUI FPGA Config: A070629BGUI PRG: 00007621GUI DAT: 37750008DGTL PLD: 00.50I left out the ethernet settings (not needed as it is my own network) and all is well with the connection. Not sure why this is not working unless there is a newer process to run the calibration. I have followed all the instructions to the letter including performing the microprocessor reset, setup the correct settings for the mic., Bi-amp disabled and it's still flashing 'Wait' on the display panel forever with no response from the remote or front panel controls. Any help would be greatly appreciated. Denon AVR-3808CI firmware update issue.stillI am wondering if there is any way to download a modified/partial firmware code to refresh the unit and re-flash it possibly via USB (?). All the units’ functions are working perfectly with the exception of Audyssey EQ.
Denon Avr 3808 Update System
I can manually configure it without a problem, it’s just frustrating to have put down so much $ for such a great piece of gear to have to face this issue. Nodaka inna ba uresha mp3. My theory is the firmware code somehow miss-wrote the code for the Audyssey EQ function but calls it out as being upgraded correctly on the display. I also am not about to tear my HT apart, pack up the unit and ship it out in the hopes that it will get repaired, not get damaged in shipping and get it back in a timely fashion all for one function that only needs to performed once. Again, I can perform this manually without issue so if I never get a resolution or a new firmware comes out that miraculously fixes it, I can live with it. Any further input (USB flash?) would be greatly appreciated.